설명
The hot rolling technology enables the material to become increasingly thinner, achieving a thickness range of {{0}}.005mm to 0.100mm.
Titanium strip weld joints can be inspected by open-flame inspection, using short-arc welding without swinging the torch or wire. When covering the surface, even if it is necessary to swing, it is only a slight and slow swing. The end of the wire can not be removed from the protective range during the welding process, otherwise the end of the wire will be oxidised. If the end of the wire is found to have been oxidised, the oxidised part must be cut off before use. After stopping welding, the gas should be fed with a lag until the temperature of the welding zone drops to below 300 degree Celsius. When welding, the starting and closing points of the arc should be carried out in the breach shall not start and close the arc on the base material.
Professional titanium material supplier - GNEE
| CP GR 1 | CP GR 2 | |
|---|---|---|
| O | .06 | .12 |
| .03 | .06 | |
| C | .01 | .02 |
| .163 | .163 | |
10-6/ degree C |
8.6 | 8.6 |
W/M x K @ 100 degree C |
16.0 | 16.0 |
MICROHM - CM |
56 | 56 |
Large-scale factory production
인기 탭: , 티타늄 파이프 열처리, 수출 니오피움 합금, 맞춤형 몰리브덴 합금, 전자 산업을위한 텅스텐 합금, 정밀 텅스텐 합금, 정형 외과의 티타늄 파이프 응용
